what raw mark do u tink u will get? (1 Viewer)

[jpk]

well...i think...i will get a raw mark of round in da 60-70% range....wat do u guyz tink?

 

[lawrencema_1985]

yeah same

 

[SmokedSalmon]

Most likely I have passed. Um... around 50/84 I think overall.

 

[detsiiFLUEY]

93 % + without a doubt

 

[walla]

hopefully whatever 81/84 is but i suspect i may have got the bearings question wrong

 

[ND]

Originally posted by walla
hopefully whatever 81/84 is but i suspect i may have got the bearings question wrong

What did you get? Was it something like 7114? (that's just a guess, i think it started with 7, and had 4 numbers)

 

[failingTheHsc]

i know i havent got 15 marks

minus silly mistakes

60 - 65 / 84

75%

 

[spunky]

60-70% here too (

 

[Matt200]

id say about 75% too

 

[hbk_ace]

70s

 

[nerdd]

yup mid 70s i think

 

[yumi]

80 i think

 

[inasero]

80 at most...if i dont have stoopid mistakes

 

[vegeta_316]

Shit. Everyone is getting like 70s.

Around 60 for me. Fucked my timing bad and couldn't get around to the big mark questions.

Shit.

 

[ViEtBoI86]

90%+

 

[mikehunt]

prob around 70 i think... i thought it was a pretty good paper..

not too hard

i will be stoked with 75% considering i only got 54% in the trials...

 

[woohoo]

hopefully 75-80%

 

[vegeta_316]

Originally posted by ND
What did you get? Was it something like 7114? (that's just a guess, i think it started with 7, and had 4 numbers)

Sweet. I got a number that started with a 7 and had four digits too.
Time for this question screwed me up too. I'm an idiot because I decided to write the tan16 and tan23 values in decimal form straight away instead of leaving it till the end of the equation to punch em in to the calc.
As you could tell it took a long time punching in all those decimal points to finally get an answer.

 

[Inhuman]

60-70%

 

[Constip8edSkunk]

i suspect i got the bearings wrong too... i thought about reducing them to decimals but that might screw up the accuracy.. so i spent 5 minutes entering all the tan's and cos's, pressed =, and got MATH ERROR... :burn: :burn:


i got 200 something for distance and 256 for bearing :\